|
|
|
Since 1998, Ace Gutter, Inc. has been providing Utah's Wasatch Front with the highest quality rain gutter services, specializing in:
• Seamless Aluminum, Copper and Steel Rain Gutter
 in K-style and half round
• European Manufactured unique styled half round copper
gutter and accessories
• Ice Melting Systems prevent ice and snow build up
• Leaf Protection keeps leaves, pine needles and debris
from clogging your gutter |
|
|
 |
|
For over 15 years, the Ace Team has applied their unique skills in the construction industry.
Although we specialize in rain gutters, we have extensive experience in many trades. This allows us to solve problems before they become problems for you.
We are honest, dependable, and understand the tight schedule you face. We'll accommodate your schedule
and be there when we say we will.
We take pride in our work and expect it to last a lifetime. You deserve nothing less! |
|
 |
|
Gutter - Screws, H-Hangers, S-Hangers, Gutter Wedges
The size of the gutter is 5" wide and 4" deep with a thickness of .027 gauge aluminum. We also offer copper k–style, half round, and commercial sizes. There are a variety of ways to install gutter. Some are listed above, but the most common is (hidden) H–Hangers. Any time the fascia board is flat and 2X, we use H-Hangers unless otherwise requested. The hangers are placed inside the gutter, 2 ft. - 2.6 ft. apart, with a 4" screw inserted through the back of the hanger into the fascia. If the fascia is angled we recommend gutter wedges - a little extra money, but well worth it. The other methods are typically used on remodeling projects.
Downspouts
All downspouts are riveted with .44 aluminum rivets which give a cleaner look, prevent rust, and allow debris to flow freely through the downspout. The outlet from the gutter to the downspout is drilled with a 2-3/8" whole saw which helps prevent clogs. The outlet is punched in the top; never drilled through the bottom or chiseled.
Miters
All miters are also riveted with .44 aluminum rivets for the reasons mentioned. The gutter inside the miter is always cut at 45 degrees, thus giving the miter extra strength and only one seam to seal instead of three. The end caps and miters are sealed with only the highest grade of polyurethane sealant, not silicone. A polyurethane sealant allows the joint to expand and contract with extreme changes in temperature; it also adheres much better than silicone. |
|
